Gen. Kit. SS3+. 3 Phase. 100W D/C high output

Super spin, 3, generator kit. 100W Output with 470g flywheel.

After 2 years of development we have created a reliable system to produce 100W constant output at a maximum of 14.7V

This kit will now cure the issue of poor lighting and the usual issue with crankshaft snapping off and being out of balance with the 1 kg flywheels.

Most of the stators that are on the market are between 40watts and 55watts. If you are running a 40W+ head light and a 5watt tail light; your on the limit of the output of the gen already.

With this kit you now can run a 55W halogen head light and many other accessories with out risk of flattening the battery.

Due to the stator is full of coils there is no room for an A/C coil for powering a CDI. It has to be run with a 4 pin D/C powered CDI unit.

Supplied with:

• Matching 3 phase Reg/Rec with control wire
• Light weight 530 gram multi magnet flywheel Taper to suit 16mm/19mm will not fit the small 13mm/16mm
• 12 pole 3 phase stator with pulse coil.
• Direct plug and play for Madass 125 wiring loom

Specifications. Stator plate and Generator Coils:

• 715g Weight overall
• 115mm diameter overall
• 75mm Diameter external core
• 100W output (Through our reg/rec)

Wiring. Generator coils:

3 x Yellow wires: output to Reg/Rec (pre plugged)

1 x White/Blue: Trigger (male bullet)

Specifications. Flywheel:

• 470g Weight (gross)
• 88.5mm Diameter overall
• 401mm Depth
• 16mm-19mm Internal Taper
• 27mm flywheel removal tool used to remove

Specifications. Reg/Rec:

• 240g Weight (Gross)
• 70mm Width
• 81mm Length
• 28mm Depth
• 120mm Loom length
• 3 pin male plug (to reg rec)
• 3 pin female plug (to loom)

The Reg/Rec wiring:

• 3 x Yellow direct plug into the stator “pre wired with 3 pin plug”
• Red to battery + via fuse, you can use the red from old reg/rec plug
• Green to earth or battery – Same as above to green or black/white
• Black + switch needs to be connected to a + feed that becomes live when the ignition is switched on

PLEASE NOTE

Must run a battery YTX 4 LBS or bigger

Will not work with electric start engines unless you remove the starter motor.