Wheel conversion kit. 10" with Girder under brace arm +8cm or + 13cm Choice on chain

This is a complete conversion kit to fit to any twin shock monkey frame. This will convert your bike to run 10" wheels +8 or +13cm Arm.

This wheel conversion kit is supplied with a girder braced swinging arm

Use 280mm to 305mm shocks no more or chain will rub hard on top of arm.

The kit includes:

• 2 X 10" 8 hole 'Pepper Pot' Wheels. Off set matched pair. 2.50" F 3.50 R
• 10" wheel kit with Metzeler seventeen tyres fitted 120/70/10 front.
• 10" wheel kit with Metzeler seventeen tyres fitted 130/70/10 rear.
• Alloy Braced Girder swing arm. 
• Chain guide rubber
• Brake rod
• Shock bolts
• OORacing 420H chain with link its 130 link so you can shorten down to you’re your gearing.

The Powder coating has been applied in the UK specifically for us.

Please note:

This is a stock picture of the +13 arm in photo

Uses stock axle and pivot spindle. (not included)

With rubber swinging arm bushes you only want to tighten the pivot bolt enough so the centre of the bush can still rotate on full swing.

Don’t run the chain too tight or it will rip out the left side bush.

Bigger CC high torque engine will hammer the bushes